|
|
|
|
electek testimonialselectek 36 recommendations from different applications
"We have been manufacturing metal hollow-ware for the past 55 years. During which time we have had problems with rust - particularly on our spun and pressed products. Spraying with electek 36 completely eliminated any corrosion problems - especially on hub caps, Wok Dishes and tools in storage. If your company is having a similar problem I highly recommend electek 36."
"We have been using the electek 36 product extensively in the servicing and maintenance of electronic security and access control systems. The product has provided us with a useful tool in the prevention of product fault and increased reliability in harsh environments."
FROM BILL HOHEPA, WELL-KNOWN FISHERMAN "We just wanted to let you know how pleased we have been with your electek 36 product. Although we initially used it to solve a problem - water getting into the starting motor - on our boat we have used it in other applications. Principal among these has been the use of electek 36 with our fishing reels. When reels get wet - and they will - water can cause serious damage to the mechanism, often needing a complete strip down to rectify. In this application we have found electek 36 very successful. It has saved us both time and money. In our other interest - namely 4-wheel off-road driving - we are fully confident in electek 36's ability to absolutely eliminate moisture-related failures in all electrics and electronics. We strongly endorse your product, electek 36, and would recommend it to anyone looking at protecting often expensive equipment from the possibility of moisture-related failure".
FROM BIGLIFT INTERNATIONAL LTD consultants for heavy lifting projects ”We are all often guilty of knocking a product when it doesn't work as we expect it to. In this case I have reversed the trend to tell you how good the product is. We had a small 12 volt DC electric motor out of an older profile-cutting machine that had been water damaged and completely seized while stored outside for some time. Unfortunately replacement parts are no longer available and, as the motor was an integral part of the frame, the cost of manufacturing a complete housing would exceed the value of the machine. We soaked the motor in electek 36. After 24 hours we removed it, compressed air-dried the motor, coaxed the armature to turn, then put it back in the electek 36 and connected it to a 12 volt power supply - and it started immediately. While running in the electek 36 it cleaned the rust from the armature. While the profiler cutter is old and worth only $3,000 or $4,000, it is working as well as ever and would otherwise have been scrapped for a $50 part. Please feel free to use this as a recommendation to others as it is a product I would well recommend." Kevin Williamson,Biglift International Ltd,Movement Engineering, Mechanical Construction, Heavy Lifting Project Management and Rigging
HYTEK SOLUTIONS LTD Working towards a healthier and safer environment electek 36 recommendations
|
